kryszak80 Posted November 13, 2016 Author Share Posted November 13, 2016 Witam.Jak w temacie,mianowicie znalazłem stalową klamrę pruską i zrobiłem elektrolizę ,tylko za mocno i teraz świeci że można oślepnąć. Prośba jak można ją postarzeć. Link to comment Share on other sites More sharing options...
Cyrograf15 Posted November 13, 2016 Share Posted November 13, 2016 Wystarczy poczekać. Nie męcz jej.Wojtek Link to comment Share on other sites More sharing options...
vis1939 Posted November 14, 2016 Share Posted November 14, 2016 Wrzuć fotę tej klamry. Link to comment Share on other sites More sharing options...
kryszak80 Posted November 14, 2016 Author Share Posted November 14, 2016 Tak wyglądała po wyciągnięciu. Link to comment Share on other sites More sharing options...
kryszak80 Posted November 14, 2016 Author Share Posted November 14, 2016 Tak wyglądała po pierwszym etapie elektrolizy. Link to comment Share on other sites More sharing options...
kryszak80 Posted November 14, 2016 Author Share Posted November 14, 2016 A tu chciałem ją jeszcze dopieściś i chyba trochę przesadziłem. Link to comment Share on other sites More sharing options...
Kriczer Posted November 14, 2016 Share Posted November 14, 2016 Szczotka na wiertarce przeleciałeś ? Link to comment Share on other sites More sharing options...
vis1939 Posted November 14, 2016 Share Posted November 14, 2016 No nieco za mocno przyciorana szczotą.Przetrzyj tylko jakim wd40 to sama z czasem ściemnieje.Ewentualnie przemyć fosolem i wymyć tylko szczotką plastikową,powinna zmatowieć i lekko zszarzeć od warstewki fosforanów. Link to comment Share on other sites More sharing options...
viator01 Posted November 15, 2016 Share Posted November 15, 2016 Ale jak czysta, to fosforanów może nie być :(Może cosmoloid z grafitem - ładnie matowi takie rzeczy i konserwuje. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.